will a transformer work when pulsating dc id applied to its
primary?? what will be the result??
- 2 Answers
- 4092 Views
- cemp, I also Faced
- E-Mail Answers
Answer Posted / pramit dutta
Transformer is transfer energy from primary to secondary.
So it needs changing flux in its core so that the flux can cut
across windings and induced voltage and current. We know,
e=-N da/dt ,where a is flux in core. So if pulsating dc id applied to its primary then the lines of flux will be constant. So e will be 0. So energy can't be transfered.
| Is This Answer Correct ? | 0 Yes | 4 No |
Post New Answer View All Answers
PLEASE ANYBODY HAVE ELECTRICAL CIRCUIT DIAGRAM FOR CHMER PULSE CD 60M SPARKING MACHINE.PLEASE MAIL ME SUPRIYAAYYAPPAN@YAHOO.CO.IN.
What is the diff. between single compression and double compression gland
we have a lot of model of rectifier but thyristor rectifier is the most rectifier that use in power system. Do you know why this rectifier is used?
10 Mtr Hight of Lighting Arrestar how much area coverd??
If a 3 phase induction motor is in off condition in the conveyor and rotor of the motor keeps moving with the conveyor than the resistance of windings of motor varies. why is it so ??
1) why a dg set shows variation of power factor and load when synchronised with other dgs? 2)Why the load sharing is not become equal in all dgs?. 3)When a dg set will not run on auto start?
According to conduit size which size wiring & how many wires can we provide wires in conduit & how can we select conduit size accordingly?
Why HT 11 KV Slipring Motors are connected in star ?
How does the slip regulator works as a startor
When we need up only in o/p 440v, so why we use directly in 11kva in input?
What is a diode?
what will happen if synchronous machine rotor fed from single phase ac supply
We have 5 Distribution sections with variable loads&We have 3 Gensets(500kva,380kva&250kva) our total load is between 400kva to 600kva. so how could we connect 3gensets.
in general it is observed in power stations, the tertiary winding is used in higher rating Y-Y auto transformer but not in Y-Y power transformer. is the tertiary winding is compulsory then why it is not using in power transformer
single phase power supply give to separate one steel coup with water, what reaction create
