what is armature reaction?explain in simple words?and what
is its infleunce on dc motor
Answer Posted / kiran kumar
the effects of armature flux on the distribution of main field flux is called armature reaction
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what is deffrence between squirral cage and wound rotor in IM?
Name two low frequency oscillators?
what is V.L.F. testing of power cable? do you know the voltage ratings, like for what rating and size of cable what rating of V.L.F. testing is used?
Explain the fundamental difference between emf (electro motive force) and pd (potential difference) ?
What are the advantages and disadvantages of open loop control system?
To make a basic instrumentation amplifier, it takes A One op-amp with a certain feedback arrangement B Two op-amp and seven resistors C Three op-amps and seven capacitors D Three op-amps and seven resistors
1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor
Maintenance of transformer???
what is the advantages of having in-built acvvvf (without seperate inverter in the control panel)in the drive system of elevators?
what is lrs tank water resistance.
why we testing the core balance of the transformer before comissioning?
Why phase sequence must be same in any ht motor or generator circuit?if phase sequence doesn't same whatever will be affect on circuit?
In electrical locomotive engines, the DC series motors is being used as traction motor. But in new engines like in WAP7 & WAG9 the 3-phase squiral cage induction motors has replaced them. So can someone tell me the advantages of induction motor over dc seris motor in engines points of view....???
Can we test the alignment of End shield and stator of turbogenerator without rotor insertion? Also how to fix maintain the alignment at site installation?
what are the problems that generally occur in power flows??