Interested to Buy Any Domain ? << Click Here >> for more details...
what is basic difference between the normal tube light choke
and electionic choke ?
- 4 Answers
- 14169 Views
- Amaron, I also Faced
- E-Mail Answers
Answer Posted / rajeev chaurasia
In Normal choke copper loss is high and operate at low pf. Hence it consume high power for same output while electronic choke operate at high pf and loss is negligible .
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
how the works electronic energy meter?
Following test should be conducted to find out relative polarity of transformenr terminals A no load test B back to back test C phasing out test D none of above
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
what is the path of thunderlightening? once both a buffalo and a person were standing 5m apart but lightening hit and killed buffalo not person?
how to select rating of HT Panel
RESPECCTED SIR/MADAM- I AM PRERING FOR SECTION ENGINEER (ELECTRICAL) RRB CHANDIGARH PLEASE SEND ME SOME PREVIOUS YEAR QUESTION PAPER OR MODEL PAPER.MY EXAM IS ON (30- NOVEMBER 2008).I AM VERY THANKFUL TO YOU. FROM- HARENDRA SINGH YADAV
what will happens if one phase is missing for 33/11kv power transfomer and why?
How much weight an electrical engine can pull??
how to calculate fault level?
What is kvar?
In a 3 phase 4-wire system. For a 3.5 core cable if all loads are single phase and balanced, what will be neutral current? will it be sum of all phase currents? Or it will be zero? And if loads are unbalanced what will be neutral current?
Is there a standard depth of gravel fill in Substation Switchyard? Please give a design/drawing. Thank you.
In our plant we have installed new MCC with ELR and CBCT which is detecting some leakage current in the system but it leading to some confusion when to check that in which feeder which is drawing current we put off the whole panel itself but still CBCT detecting some leakage current so can anybody ans me , where i am going wrong or how to detect whether its actual leakage or CBCT malfunctioning.
CPC cable .PVC \1C....I want to get sure that type is flexible indoor or to be install on trench. please advice .thanx :)
What is meant by stator?
