For 300MW and over a distance 250 km, what voltage be
selected? and no. of circuit?
Answer Posted / saurabh bhardwaj
the emperical formula for this,
kv =5.5 under root((km/1.6)+(load in kva/150))
Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
What is the need for a controller?
Load break swicth maintenance procedure.
why the earth is taken minimum in supplying? wather it the proportional factor to getting work any equipment or a power plant?
we have a 2.5hp Starite electric motor water pump,the elec motor burned out,we need to replace starting capacitor(old capacitor specs erased),what microfarad rating capacitor do we need? 110-125V
Name a govt approved university which have 100% online engineering course.
Cb closed condition if there is a tcs fail whether cb will trip or not
which network topology offers the greatest level of tolerance?
What is Phase to Phase clearance for 800V System Operating Voltage as per IEC61439
where rlc series ckt used?
solar inverters was not connected to the nuteral link .this nutwral possible to any other systems
either water sensor or flow meter,how we observe the water level, f any other equipment are in market ?
If only R Phase is connected in 2 pole elcb, n is not connected than it will work or not in ground fault.
What consists of 2 or more thermocouples to be connented series?
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
What does the term power factor shows?