Interested to Buy Any Domain ? << Click Here >> for more details...
where can we use viberation
transmitter,and how can we control
viberation?
- 1 Answers
- 4797 Views
- Maden, I also Faced
- E-Mail Answers
Answer Posted / abhijith
vibration transmitter
normally used in
compressor, turbine to
measure the vibration by
adjusting the gap voltage.
we cant control vibration
it shows only vibration
reading.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
In bently nevada vibration monitoring system,what is the reason to maintain the Resistance of the probe + extension cable equal to 95 ohm? If possible explain the basic principle of measurement with detail electronic circuits.
Good evening all I need a small favour regarding reliance paper i wanna probable sample papers(e&i) of reliance. if any of u have any idea about dis then plz mail me back.i belongs to electronics and instrumentation engg.so i need e&i papers. thanking u....
can you send remote seal interface level transmitter calculation steps for oil water saperator.
Explain the use of hair spring in the pressure gauge.
Why all the drains(Gland sealing,ESV,Casing inlet etc) are directly connected to the flash tank instead of hotwell of the condensor in the power plant? My Email Id:naba02222@gmail.com
Decibel.
How we calculate orifice plat size???
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
what is the calibration procedure for transweigh make weigh feeder?
Can anybody tell me how to select the size of earthing cable for DCS & PLC system.Please tell me any relevant answer here or mail it to me.
What is compensation for flow ? Why we use compensation ? What are the factors of different compensation ? We not use then what problems may happen ?
What is the exact differences between HART,FOUNDATION FIELDBUS,PROFIBUS?
In turbine what does term CDP, NH, HSSOC means.
What is modbus?
What is loop1 and loop2 in MTS LT?
