Interested to Buy Any Domain ? << Click Here >> for more details...
what is the use of impulse line in AFBC boiler , WHY WE
CONNECT IMPULSE LINE TO TRANSMITTER , DRFT GAUGE ETC ????????
- 6 Answers
- 15566 Views
- Jindal, Reliance, I also Faced
- E-Mail Answers
Answer Posted / ak
in dp transmitter if we didnt used impulse line steam or
foreign particular amy enter to the transmitter that will
cause sensor damage thatsy for condensate the vapour
impulse lines are used.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
For crude application in floating roof tank, how to calibrate a DP Transmitter? How is the floating roof weight considered?
Isometric drawings are generated during _________________ phase of a project
how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.
why is an oxygen sensor used in a boiler stack
1- Explain about HPM 2- What is the FSC and explain the configuration of FSC 3- explain the complete loop of vibration, how it works (field to control room) 4- What is the use of proxymitter? 5- During job your partner effected with H2S then what you have to do. 6- what type of gland packing uses when valve glind is leaking.
what is the calibration procedure for magnetic flow meter @ onsite
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
If we increase only P what will be controller action ?
field bus transmitter calibration procedure tell me
Calibration procedure for water rotameters
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
What is zone,loop/fire alarm system?
How oil line flow measured?eplain about instruments used and working principle?
Can Any body tell me about the Contact or Email id of any good Consultancy which help me to find a job in Instrumentation Field in India .I have Six years of Work Experience in the Same field.Please revert me back on shammi_gwalior@yahoo.com ?
Hi Friends i need Electronics&Instrumentation Engg question papers for BARC written test by coming 20th May 2008 pls post ur use full info to kkumarei@gmail.com. Or for suggestions pls give one missed call to 9962122264
