Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between LPF and UPF wattmeter and
where it is used.
- 7 Answers
- 78684 Views
- I also Faced
- E-Mail Answers
Answer Posted / suresh
HERE LPF USED TO measure the low current & UPF is used to measure the high current. Then low pf and unity power factor
| Is This Answer Correct ? | 10 Yes | 26 No |
Post New Answer View All Answers
How to calculate capacitor bank size at a load 800kVA.
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
What is the maximum operating temperature for a thermoplastic insulated cable?
What are reasond for high wattage in single phase induction motors
What is the difference between solid grounding and impedance grounding?
Draw a SLD of HT distribution EB grid up to users Transformer?
working principle of oil startar
what is meant by power and distribution transformer ?
How RTCC panel is working and give single line diagram for RTCC with transformer?
Dear sir, In our plant have Station Transformer having capacity,i want to know, why LV side 40 - 40MVA is given? & how we can get 6.3 KV supply from tertiary(i.e. Open delta connection), Vector Group YNyn0 - yn0 +d MVA Rating 80MVA / 40 - 40MVA + 26.7MVA Voltage rating 420 (Tap range +6,to -10)81.25% /11.5KV - 11.5KV +6.3KV
pre arcing time of ehv breaker
what is difference between 9kv 5ka surge arrester and 9kv 10ka surge arrester.
Why should be the frequency 50 hz 60hz only why not others like 45, 95 56 or anything , why should we maintain the frequency constant if so why it is only 50 hz 60hz?
How to synchoronize the generator (with gcb,GT) to grid????? ????? from Grid iam getting power (rated 400kv/20kv) through GT and its goes to UAT.,,ST.,, now my generator(rated 20kv ) ready.,, now iam closing my GCB.,, in GT iam suddenly giving 20kv on that Gt.,, what will happend
what happen if the load connected to the induction motor is taken away? the same question for synchoronous generator in synch i think that the the exitation voltage will appear on the terminal only if so plz answer me
