Answer Posted / anoop dwivedi
basically k type tc is mostly used,b'coz its range 0 to 1250 and less cost
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
what is SIL 1 2 3
Hi Friends i need Electronics&Instrumentation Engg question papers for BARC written test by coming 20th May 2008 pls post ur use full info to kkumarei@gmail.com. Or for suggestions pls give one missed call to 9962122264
how to check earthing,what is minum ohms for proper earthing
Where is wet leg is used?
i need some objective type questions in instrumentation
hiii.... can any one provide me previous years question paper of hindustan petroleum for instrumentation engineering???
How d.p. Transmitter can be applied to close tank?
what is wave length were using ?
WHAT ARE THE INSTRUMENTAL DIAGRAMSOF VALVES?
diff between neutral ,ground,phase , earthing and shielding?
How can we use feedback signal frm rtd for monitoring and in dcs for controlling ,then which type of rtd is sutaible 2 , 3,4wire and why ?
In my company plc based winders are operated. one day there was a data transmission failure alarm shown on pc. as per sir instruction we have reset master plc but winders were not triped and alarm gone. so what master plc do?
How to calibrate an pressure gauge with yantrika test bench?
What is zone,loop/fire alarm system?
How to calibrate H2s Dectector