Answer Posted / koti
It is not minimum but maximum which is less than 1 ohm.
Is This Answer Correct ? | 6 Yes | 2 No |
Post New Answer View All Answers
What is the permissible maximum flux density in transformer core?
How REF protects transformer alone? explain with diagram.
What is the permissible limit of shaft voltage for 6.6 KV motors ? Why? Is there any standard is available?
how to calculate the fault in substation
what is negative and zero impedance in 3 phase induction motor ??
When calculating the speed of a rotor required for a particular frequency of synchronous generator we use the equation 60f/p Is this p is the number of pole pairs of rotor & do we consider the number of pole pairs in the stator is 1?
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
what the principle of sincroscope?how it works?when it needed?
How to check 11000/1.732 to 110/1.732 Potentila transformer (PT)?
Why we find the sensitivity for the CT's to check?
if the number of poles generated in stator and rotor side of an induction motor are different then what will happen and why?
pls tell me about ups internal connection & we have given only 3 phase supply to ups system how get 4 wire (R Y B N )
1)Explain why the cradle guard is used on railway crossing in overhead line construction?
Can we check ELCB constantly from R1 to R8 phase in 1 no DB?
what is the power factor used by the PHCN in nigeria? 2. what is the difference between an alternator and generator. 3. Generation of poweris in KV but how is transmission is in MW. 4.If the transmission of power is 20,000MW how can it be increaesed to 80,000MW