how to calculate temp.prapotional to mv in thermocoulpe.
Answer Posted / mallu byali
Mohammad Asfani
as our Colleague said that is also right, but one more
simple way is that 1 mv is equal to 25 degree you can
calcutae bases on mv.nothing more
for ex 5 mv at element side then temp is 125 degree.
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How many types of sensor
How digital input and digital output 's are working in dcs
what happen if i increase height of displacer type LT.accuracy or sensitivity are affected.why?
what is the difference between magnetic flow meter and mass flowmeter
CONTROL VALVE OPERATING IN MANUAL BUT NOT IN MANUAL. WHAT SHOULD BE THE PROBLEM ?
can we replace a slot sensor (inductive type) with limit switch (potenial free contact / no-nc type).
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
why micro controller 8051/52's clock frequency is internally divide by 12 ?? and why it is further divide by 32 in UART serial communication ??
Is there any relation between Artificial Intelligence and Instrumentation?
I want to apply for the universities in US,but i got the GRE score of (650+300=950)TOEFL 69/120.Is this score sufficient for applying universities please i am married i need to go to US because my husband didn't get H1 yet.please send me suggestion
Hook up resistance decade box to temp.transmitter.
sir,would you please send me the Hindustan petroleum corporation limited papers(HPCL).my e-mail ID is ujjwal_sharma1983@yahoo.com
How can we test a bently nevda 3500/42M accelerometer monitor card by simulating it with test equipment?. what king od of signal (milli volts or volts or or resistance ) we should feed in the terminals of the card?
What is the difference between ff transmitter and non ff transmitter