Answer Posted / rasik
An angle between current and laging voltage
Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
A commercial Building is designed with 14th floor levels with indoor substation of three phase transformer with rated capacity of 1000 Kva.The transformer delivered 65% of its rated capacity at 0.67 power factor lagging.Because of low power factor, the power customer was penalized and certain cost was charged accordingly based on every point percentage lower than 85%.This situation may repeatedly happen on the succeding energy bills of power customer.The power customer is desired to improve its historical power factor of 0.67 lagging and no further penalty be impose by the local power company on the next bill. Q: Identify the appropriate solution you want to offer to Client?.Justify SCIENTIFICALLY and MATHEMATICALLY the principles behind the solution.
How servo stabilizer works.
What is the rating factor for copper cable ( Specific value according to the type of laying ) & the voltage drop?
What is meant by stator?
What happen if 200 KVAR capacitor connected to power continuesly?
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
salam,hi, i need to know what the spesification of 300amp msb...
how to increase senstivity of ct
Phase control and integral control are used for?
for a 500 KVA connected load, I calculated 30% of capactor for power correction. Even after using 225 KVR capactor PF is not improving. What could be reason for low Phase correction factor?
how to CHECK CT AND PT AT THE FAULT OCCUR IN GENERATOR RELAY PANEL .
What are the various kind of cables used for transmission?
What should be the protection scheme for a 15kw, 3-phase motor working in a lathe machine.
In india, according to trade theory above 5 HP motor reqired star delta starter. But we R connect 11 KV motor with 14MW in Direct to line ( With VCB starter combination) Can U Guess, How it is possible ?????
What are the factor to be consider for CT selection in 132kV substation?