how to define vector group of
transformer
- 1 Answers
- 4921 Views
- Engro, Reliance, TATA, I also Faced
- E-Mail Answers
Answer Posted / najamkccl
the vector group designation indicates the winding
configurations and the diffrence in phase angle betwen
them(HV,LV).
FOR EXAMPLE.
a wye HV windings and delta LV widing with the 30
degree lead is denoted as Yd11.
| Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
what is p.s impedance measurement test in earthing transformer?
Define peak overshoot.
how to calculate insulation level of transformer?
how many types control panel of a 132/33 kv substation
What are stable systems?
Actually I have a doubt on neutral and earth.we use Ac power without taking neutral by connecting to earth,but at that time does it affects on efficiency of any electrical components or no? If yes how?
If 100 KAV USP dedicated earth got disconnect / Cut. What will happen at load.
How to calculate the External Resistance required for 60HP slipring motor in case no any data of the Motor is available???
can any one know is sbi interview based on merit or based on roll number
What mean by MLTP
what is the purpose of high speed earth switch in gas insulated substat
In diesel generator how AVR get voltage to excitation. And basic diagram DG EXCITATION CIRCUIT.
WHAT IS DOL STARTER? HOW IT WORK? GIVE ITS CONTROL AND POWER DIAGRAM .
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
what is the voltages using in movie theaters??? why ??why not other??
