what is purpose of using reactor in substations.
Answer Posted / r.mukesh
Shunt reactors are designed for connection to the ends of high voltage transmission lines or to
high-voltage cables for the purpose of controlling the line voltage by absorbing reactive power.
Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
Why do we avoid electrical conduits in floors at apartments?
what will happen if OLR CT in all phases are short circuted
Why can't we take NO LOAD TRIAL of motors having V1 mounting??
Explain about p.t?
What happens if i apply 500V to 440V rotary Switch ?
Is it required to lay GI wires along with GI/MS conduits from one point to another point though separate earthing cable is conncted from DB to Socket?
when it is possible kvrah lead & fundamental kwh be equal in electonic trivector meters (3 ph)
how oltc works in rectiformers of higher rating (27 mva,200v dc,120kamps) please provide me full information with diaggram.
What is the difference between grid and off- grid system??
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
How to operate a ac chilar plant?
What is vacuum circuit breaker.define with cause and where be use it device?
why we use circuit breakers for switching instead of normal switching device?
Whether amorphous core transformer is available in India?.If available then up to what rating of voltage and KVA?.
what is meant by 3rd hormonics ?