what the purpose of protection signaling equipment in
substation?
- 2 Answers
- 8270 Views
- I also Faced
- E-Mail Answers
Answer Posted / zizo
PSE act as isolator between protection equipment and
communication cloud.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
where solid grounding and where grounding through ngr done and why?
what happens when series resonance occurs?
direction of tarbine& genrator
How to calculate cable size in HT AND LT
Determine a suitable number of slors and conductors per slot for the starter 1 winding of a 3 phase, 3300 V. SO Hz 300 rpm alternator. The diameter is 2.3 m
if there is nutral in phase why we use earthing wire and grounding? even at fault condition the fault current flows to neutral (it is a lower path)
what is the difference between earth leakage and earth fault?
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
what heppend if we are connected u1-v1-w1 as a star point in the place of u2-v2-w2 in power genration
why cable i burning without tripping. how can protect led street lights
Why does the radius of armature is less than the radius of pole shoe?
A cylindrical wire is compressed in length by 10%. The percentage decrease in the resistance will be?????
please send me jindal previous aptitude and technical question and answer.my email id is deep_raj@live.com
by what factor the starting current is used when comparing star and delta connection for motor starting?
Two liquids hot and cold in two vessels are there and an metal bar acts as a conductor of heat between the two vessels. what happens then. what happens after 24 hrs?
