Interested to Buy Any Domain ? << Click Here >> for more details...
whats happen if we disconnect the NGR of alternator in running condition?. Generally we observed that transformer netrul is directly grounded but alternator connected with NGR, then ground?
- 1 Answers
- 4577 Views
- I also Faced
- E-Mail Answers
Answer Posted / ayush
we certainly cannot do this but we anyhow do it the unbalanced voltage in phases will run out and disturb the windings and under or output voltage can occur
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
I HAVE A INCOMING 100A MCCB TPN 25KA, CABLE LENGHT OF 80M 70MM CABLE SIZE FROM MAIN SUBBOARD TO NEW DB.BASE ON THE FAULT LEVEL SETTING OF 45KA.I WOULD LIKE TO FIND OUT 25KA ENOUGH KA. APPRECIATE IF SOMEBODY CAN ASSIST ME WITH FORMULA FOR THIS. FRM: JEFF
how the phase convertor changes the no. of phases
A 7 storey building has a floor area of 35,000sq.ft on each storey. On the ground floor 11KV electrical sub-station is to be erected. A load of 3kw for every 400sq.ft (p.f is 0.8) is proposed for each floor. fire pump 7.5hp, water pump 5hp, lift 2 nos, each 10hp and 20shop load of each shop is 5kw. calculate a. load each floor b. total load of building c. L.T feeders for aech floor and from transformer to main. d. distribution diagram e. capacity of sub-station/capacitor bank f. line diagram
Why are short circuit ratings always 16kA,25kA,36kA and 50kA.Who has fixed these?
Explain the method to keep noises low in a control system?
what is the practical application of full adder circuit?
What effect does a very low impedance have on the Voltage regulation? On the short-circuit current?
how slip power recovery system work
I'm looking for a mnaual set for a Teradyne J750. Softcopy would be preferred but I'll take what I can get.
What are the types of piano switches?
What is the function of interposing current transformer?
what are the values of VRY,VYB,VBR,Vry,Vyb,Vbr,Vrn,Vyn,Vbn for Magenetic balance test of 100 KVA and 63 KVA Distribution transformer
Why in metering Ct for ammeters ct secondary side is grounded for each Ct but not in case of CBCT (Core balance current transformer)..kindly some1 highlights the reason..is it because net flux is zero?
In power transmission using open belts or horizontal shafts it is preferable to have the slack side of the belt on the top because
HOW TO WRITE A QUENTION ANSWER? I MEAN SHORT OR LENGHTHY ? OR FROM THE BOOK AS BOOK..... SOME TIME WE GIVE A ANS FROM THE BOOK AS LIKE BOOK ND WE GET MINIMUM 60% MARKS OR MORE THEN....... THEN HOW TO FILL THE Q-PAPER?
