Interested to Buy Any Domain ? << Click Here >> for more details...
What is the maximum current carrying capacity for both copper
and aluminium cables for 1sqmm?
- 2 Answers
- 4619 Views
- I also Faced
- E-Mail Answers
Answer Posted / venkatesh
For cu 1sqmm= 6A
For al 1sqmm=1.5A
| Is This Answer Correct ? | 8 Yes | 3 No |
Post New Answer View All Answers
High voltage test procedure of in swgr board. why should measure millivolt drop on testing time?
63MVA,220KV/6.9KV Transformer LV side neutral is connected to Earth pit through NGR. Whether this earth pit required to connect with near by below grouding earth mat or it is to be kept separate?
While HT line put on to activate ACB in low tention panel VCB tripping instantly.why it happens
why they were using TRIAC instead relay in some controllers and what is the advantages.
Do closed loops systems require manual input?
which are the criterias needed to select the kind of neutral earthing(solid earthing,resistance earthing,etc.) at various voltage levels in electrical distribution?
Why Water motor is not taking a load or pressure while everything is correct. (Note: Motor running properly)
Dear all: Recently we got a question about Interface between PMS and SAP-PM.once we got a update message from PMS.we should set the deletional flag for functional location in SAP system.Is there any FM or BAPI to use?There are only functional location create and change provided by SAP. Best regards!
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.
Shall I use 40A semiconductor Fuses in 32 A SFU ? Frame size is same. What Happen if Fuses burn on SFU?
how to calculate fault level?
Why do power lines not short out when they fall into water?
How to design the NGR Resistance
How dia computation perfomed in cold rolling mills .
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
