Interested to Buy Any Domain ? << Click Here >> for more details...
why so voltage is same in parallel circuits and current is
same in series ckt?
- 3 Answers
- 5860 Views
- I also Faced
- E-Mail Answers
Answer Posted / daiwat natu
I m Asking Why It Is So???
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is dynamo?How it works and what is the function of dynamo in a DG.
why 5kW motor becomes unbalance if its relay trip 1st time and its set value is 7.0 A
what happens when series resonance occurs?
11000volt DG set carnt kaise banvay
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
I would like to know that the fault curretn at base load and at 10% generation will be same? Fault level of BUS remain same with different generation?
What is big transformer parts and their function ? Ty
What is magneto on a gas generator. how it functions. its out put is d.c or a.c. how it can be checked for correct functioning
Why is the frequency not changed during transformation of electrical energy in a transformer?
WHAT ARE THE EFFECTS OF SERIES RESONANCE AND PARALLEL RESONANCE ON THE CIRCUITS PARAMETERS?
If a 3 phase induction motor is in off condition in the conveyor and rotor of the motor keeps moving with the conveyor than the resistance of windings of motor varies. why is it so ??
What kind of preventive maintenance are there for transformer?
what is protection class current transformer.
What is instrumental error?
