Interested to Buy Any Domain ? << Click Here >> for more details...
what is the use of bottom reinforcement in Cantilever Beam?
- 4 Answers
- 15198 Views
- McNally, I also Faced
- E-Mail Answers
Answer Posted / siba1987it
In Cantilever Beam, Tension in top and Compression in
bottom where as nor beam had tension on bottom and
compression in top. so, for to bear tension we use main
steel.
| Is This Answer Correct ? | 4 Yes | 4 No |
Post New Answer View All Answers
5. Two long boundary walls run parallel to each other at a center to center distance of 1 meter apart. The width and height of the first wall are 0.30 m and 2.5m respectively. While those of the second are respectively 0.18m and 3.5m. Plot the distribution of vertical stress intensity due to walls on a horizontal plane, 1m below ground level. The walls have negligible depth of foundation and are made of brick masonry (y = 19.2 kN/m cu)
how will calculate 4"thick solid block quantities 1m3 sand cement ratio and breack up detail
what is meant by sustainable developement as far construction field is considered. Give suitable examples to explain the same
Water filter calculation formula
Why does the pressure increase under soil?
what is the percentage of silt in black cotton soil.?
what is a well
do we consider shrinkage factor for calculating cement consumption for CM mixes for different works?
punj loyed and sapurjl palanjl
how much shouid be the rate for ready mix concrete per cubic meter
why are you joining in this (applied post) job and your aim for this job
How do you convert wind speed into force?
how to caliculate required amount of cement and sand required for 1cu.m.
What is the significance of cost estimate knowledge for an architect?
Difference between pre-tensioning and post-tensioning.
