Answer Posted / rampal
Beta is a ratio of orifice dia to inside pipe dia.
Beta = d/D
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
Q1: Consider part of a control loop, which excludes the transmitter, consisting of a process, a controller and a control valve which may be represented by two dead times of 0.5 min each and three exponential lags of 0.8 min., 1.0 min. and 1.5 min. respectively. We wish to express this system as an overall first order plus dead time (FOPLD) model ie gain, time constant and process dead time. (We will see later that this is often done, to simplify controller tuning). For this exercise, gain is considered to be 1.0. (A) If the transmitter is a flow transmitter whose behaviour can be described by a dead time of 0.2 min. and an exponential lag of 0.5 min. in terms of the overall dead time and overall first order lag how can the system behaviour be approximated ? Overall dead time = Overall time constant = (B) If the transmitter is a temperature transmitter with a temperature sensor in a protecting well whose behaviour can be described by a dead time of 0.7 min. and an exponential lag of 15 min. how can the overall system behaviour be approximated now? Overall dead time = Overall time constant =
how to tune siemens sipart electro pneumatic positioner..plz tel me..
Why not come out analog output in ABB EL3020 when display show correct value
How to work temperature gauge?
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
how to check earthing,what is minum ohms for proper earthing
please can any one tell me clearly about pid tuning i am confusing about this .how to tune pid easly?
What is the calibration procedure of Drum level transmitter if range is 0 to -400 mmh2o in lab?
why we use impulse line of flow transmitter at 45 deg. angle both side of orifice plate.
how to calculate control valve bonnet size?? or how to select its material?
Make a ladder diagram on LSL valve will close, on PSL valve will open and start the motor
steps for installing orifice plate?
How is work 5/2 sov?
How to Calibrate Interface Level Troll in field
what is droop in governer ,type of droop ,how it work
