Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / shah behram
Any fluids or liquids flowing from one place to another place is called flow and it is defined as volume per unit of time at specified temperature and pressure conditions,is generally measure by positive- displacement or rate meters
Units:Kg/hr,litter/min,gallon/min,
| Is This Answer Correct ? | 10 Yes | 0 No |
Post New Answer View All Answers
What is limitation of the ht.of the displacer of a level trol?
why Fahrenheit unit of moistur analyzer transmitter
is motorized valve closed when power shutoff?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
what is easiest way to read STL language in PLC?
why we are using drum level control valve air to close?
why we are using digital signals for I/O & how to measure this signals is getting or not ?
What is stripper & spilitter ? Diffrence in this.?
any body please send me the old question papers of ongc test.
field bus transmitter calibration procedure tell me
Can Any body tell me about the Contact or Email id of any good Consultancy which help me to find a job in Instrumentation Field in India .I have Six years of Work Experience in the Same field.Please revert me back on shammi_gwalior@yahoo.com ?
what is exact time to study dcs and plc cources
how radio frequency level probes works with its controller ? what is its principle ? pls give me brief explanation?
State bernoulli’s application.
What is the use of control cable?
