why is that a 4*4mm cable,is always powdered internally
Answer Posted / jerry_shogs
so as to avoid their insulators sticking together
Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
what is transient stability analysis means?
what do you mean by type zero control sytem ?Give an practical example of type zero contol sytem?
what is the importance of earthing system on the generators big capacity and small?
what are factors to be consider to design a HT & LT motor?
Define the term Capacitance and Inductance?
What is reverse power relay?
i have total 8 dg sets for synchronizing and 2 buscoupler,1 sectoin dg no 1,2,3,and 2 sectoin dg no 4,5,6,and last section dg no 7,8 ....if buscupler no 1 and 2 is off mode ..than dg no 1,2,3,will synchroniz of another dg sets?
how can i change the rotation of the AC single phase induction motor and show me by diagram
I Need standard operation procedure(SOP)for 500kva Oil type transformer oil filtration & Procedure for IR value checking.
if in 3-phase system voltage=440V,frequency=60Hz, current=400A. then if it is single phase then current=? and if it is single phasing then current=?
please send me privious exam's queation papers of section engineer(electrical).
does the Trivector Meter of three phase automatically takes care of the low power factor and gives the reading accordigly or it does not take care of the Power factor while giving the readings please explain
why in the three pin plug all 3 pins are cutted ?
what is the difference between interconnection and intraconnections in the circuit diagrams
What are operating procudures & Safety precautions to be observed while operating OLTC in manual mode ?