what would happen if u assume to insulate all the overhead
lines and no insulators....??do you think it to b an
advantag or a disadvantage??justify.
Answer Posted / sunil kumar kr
In my opinion insulating the entire length of OH conductor will be a disadvantage.
In normal bare wire construction heat is easily dissipated to surrounding atmosphere. When fully insulated heat transfer reduces. This necessitates increase in conductor for the same power transfer. The thickness of insulation required will be much more considering the supporting point on towers. So the conductor weight increases requiring more heavy tower structures. Also it creates more sagging problems in summer seasons.
Also I do not think it will increase the safety much because, if broken down, it will certainly create safety threat and severity does not reduces much.
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what happen if field of dc shunt motor opens? what is function of putting res. in parallel to one phase of 3 phase IM? the power supplied by 5A source in circuit is given by------Watt.
advantages & disadvantages of Lagging and leading power factor .
What is meant by turbo alternators?
how maney type tempereture measurement ?
Define the three phase formula fuse.
How eddy current generation support the idea of train braking?
IF alternator SCR value will be high means what happen in alternator efficency at operating power factor of 0.8
what is mean by kneepoint voltage? when it will happen? ( my doubt is, if CT secondary is open means ct get saturation or blas? what are factors are required for calculations? plz give currect anws:
where the lexical paramater will use in fron end?
why to use freewheeling diode ( diode in revers bias mode) across dc coil
what is formula to cal cute earth pit numbers and size of earth strip used in earthing?
solar energy light efficiency & disadvantages?
why we are not giving the zone 1 trip command to the master trip relay
What will be the current drawn by HT motor, if low voltage is applied.. any formula to calculate the LT amps of HT motor.?
What happens to voltage when current through the inductor is constant?