Q- Which of the following is Close loop system -
a-)respiratory System b-)traffic light system c-)washing
machine d-)Room heater
my option is A, what is our take on option B & C
Answer Posted / carl_ellis
A room heater has a thermostat which senses room
temperature and turns the heater elements on or off, as
needed. It is close loop control.
A washing machine can have a closed loop feedback loop, for
example, water level, where a knob sets water level desired
[setpoint], a sensor detects level and turns off water
valve when satisfied. But the overall wash, soak, rinse,
empty, fill, spin functions are sequenced on a timed basis,
which is classic, open loop, non-feedback control.
Likewise a traffic light system can sense the presence of a
vehicle at an intersection, which enables an upcoming light
change, but the sequences of light changes are timer based,
open loop, non-feedback control.
Carl Ellis
Measure First
Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
what about your moleg in pogrees with company
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
what is Best Among SINK Or SOURCE Type Design In Digital Signal, Either Iput Or Output? WHY?Can any one..
What happen if we install my pressure transmitter below the elevation of pipe in natural gas service?
can u plz send me technical questions asked in SCHNEIDER ELECTRICAL technical paper?
Calibration procedure for electro magnetic flow meter
while i check zero check for dp flow transmitter some fluctuating came (0 to 458 kg/h) what is the reason?
hello sir/madam, I,Subramanian need 5yrs placement papers of officer trainee of Instrumentation technology.pls send to this mail id mani_nxtgen@yahoo.co.in please do the needful. with regards, subramanian.v
why we are not using the turbine flow meter in the steam service?
in which principle pressure tx,level tx ,flow tx,temp tx ,control valve works?
Why mixer nd grinder Is example of constant torque load not variable torque load ???
Reason for capillary type dp level transmitter fluctuation
why direct mounted pressure transmitters is always installed with DBB ( double bleed block) valve in process line or top of the tanks ?
i hav applied for the post of engg. in iocl so please require the past test papers fro instrumentation engg please please help me and send me the papers or tell me the pattern and type of ques asked in examination......
How to calibrate RC Feeder system in thermal power station?,If any instrument available to calibrate it,ple inform me. make:stock,