Interested to Buy Any Domain ? << Click Here >> for more details...
how to reduce disel generator voltage from 410-60 hz to
380v-60hz
- 1 Answers
- 4832 Views
- I also Faced
- E-Mail Answers
Answer Posted / ramesh
from AVR
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
how we design a pannel to start 10HP motor with the help of star delta starter?
why are u join ntpc
how much leakage current is allowed in MC61A L&T make relay?
i have faced a problem in ro plant grunfos make bm30type pump it is 22kw pump. We start this pump using siemens 3rw 4423-ibc44, 30kw softstarter but this soft starter will frequently failier so we planed to change dol starter. So pls tell anybudy its possible or not.
What is purpose of reactor?.What is different between line and bus reactor?
ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]
suri transmission
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
along with technical test papers
what happen ehen synchronisation is done at below rated speed
Is it possible to download the Siemens Selection Chart(TYPE 2 coordination) for 1) fuseless selection 2)Fuse selection
why can we use cosine wave instead of sine in ac supply as both have same rms vale and ripple factor
what is the pre charge circuit,what will be work which function it will be use plz tell me
Why do not we prefer non conventional sources of energy to conventional sources?
On what cycle does thermal power plant operate?
