what is zero trim and span trim?. at which problem we need
to use this?
Answer Posted / krishnamohan
starting posiner problem zero adjustment
| Is This Answer Correct ? | 3 Yes | 6 No |
Post New Answer View All Answers
Explain the working of rota meter.
what is a vortex flow meter,mass flow meter and electromagnetic flow meter.particular use of this.means in which condition particular meter is used.
What happen if I install my pressure transmitter below the elevation of pipe in natural gas service?
the output of the common trasmitter protocol in qatar gas are the following
typical loop drawing of a simple feedback control comprising of one transmitter and one control
What is the PLC configuration in Cement industry?
What is Erosion in a control valve?
What is the use of single seated valve?
What is profibus?
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
How to do gas analysers calibration in AUTO and Manually by using zero and span gas?
describe flow nozzel principle?
What is compensation for flow ? Why we use compensation ? What are the factors of different compensation ? We not use then what problems may happen ?
hi friends,im an instrumentation and contol engg student,can u hlp me of suggsting barc written question paper,my id is roysuvaranjan@gmail.com, cel no.9563591747
I want to know about DDCMIS in detail ? please explain it. Also give name of reference books in which it is explained in detail in very simple manner.