what is the major difference between dc generator and
synchronous generator?
Answer Posted / 7anoter4
In three phase system the 3 phases windings are even
distributed along the stator periphery and since the 3
phase currents are 120 electrical degrees in time
distanced one from each other ,then an apparent rotating
magnetic field is installed[as an armature reaction].
The synchronous generator rotor rotates in the same time
with this field [stator itself does not move]. [differently
from the asynchronous[induction] generator in which rotor
velocity is more elevated than this field velocity and the
difference depends on the load.]
In d.c. generator no such rotating field is generated as
the armature reaction is always in d.c. field and it is
rotates with the rotor together[one could say it is
also "synchronous" rotation].
However this field disturbs the collector operation in the
commutation process.
In order to avoid this, commutation auxiliary poles are
located between excitation poles and are supplied by
armature current.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is difference between Sample test and Routine test in safety standard?
1sq mm dc powr cable can carry how much dc currnt
how we can calculate the efficiency of a diesel generator ?
How we can determine short circuiting current any plant and for example a plant which power generation is 415 volts and plant load is 500 kw.
how to select the double earth conductor if 21A full load?
what is the profesional board for electrical engineer what is thepast and during construction for electrical engineering
How to use earthing on shipments.
What is kvar?
Pls Breifly explain about UPS (Inverter,Reserve,Rectifier,Float voltage,Boost voltage).
I need the list of Universities who have summer intake for BS degree in Electrical Engineering.?
Explain the construction of the conservator, operation and purpose, and draw the diagram of the conservator.
why lightning arrestor are made in two stack of insulator but why not cvt
If there is major % of Voltage harmonics in the system, how can it be control or reduced?
Explain the difference between verilog task and verilog function?
how can i reduce sparking without stepdowning the voltage