Interested to Buy Any Domain ? << Click Here >> for more details...
what is the meaning of bus bar, in electrical panels.
- 13 Answers
- 50160 Views
- HLG Habtoor Leighton Group, I also Faced
- E-Mail Answers
Answer Posted / kriti ranjan
Busbar is a strip or bar of copper, brass or aluminium that conducts electricity within a switchboard, distribution board, substation, battery bank or other electrical apparatus. Its main purpose is to conduct electricity, not to function as a structural member.
The cross-sectional size of the busbar determines the maximum amount of current that can be safely carried. Busbars can have a cross-sectional area of as little as 10 mm2 but electrical substations may use metal tubes of 50 mm in diameter (20 cm2) or more as busbars.
| Is This Answer Correct ? | 11 Yes | 2 No |
Post New Answer View All Answers
How phase to phase voltage comes 440V.
How to calculat the ratio of HT\LT in energy meter
what is meant by tranformer impedance?
l&t switch FN 63 handle position can we change
When calculating the speed of a rotor required for a particular frequency of synchronous generator we use the equation 60f/p Is this p is the number of pole pairs of rotor & do we consider the number of pole pairs in the stator is 1?
hi frnds what is meant by harmonics & what is meant by third hormonics,where its will occur ?thank u
why moisture formation found in XLPE Armoured cable outer sheath
How many double suspension hardware fittings are required on a double circuit transmission tower?
The magnitude of sum of two sinusoidal av voltage is equal to 230 volt.the magnitude of each individual voltage is also equal to 230 volt.what must be the phase difference between voltages?
How many types of probe used in cro?
a 100mva,400/200v transformer has leakage impdce of 10% draws a steady state line currentof---------------
1. How many types of mangers? 2.How many types of capacitors? 3.pls tell me normally types alternator problems?
How to know Resistance and Reactance value of main and aux winding of single phase capacitor start capacitor run induction motor to find capacitor value?
When will you multiply and devide with derating factors to the actual value while sizing the cable?
While performing stability test of differintial cts how to know the voltage and current on both side of the transformer?
