what is the difference between id fans and fd
fans
Answer Posted / m talha aziz(cap)
In a balanced draft boiler you actually have both F.d fan and I.D fan.
1. I.D stands for Induced draft Fan whereas F.D stands for Force Draft fan.
2. ID fan(Induced Draft Fan)basically pulls out flue gas from
the furnace of boiler. FD fan(Forced Draft Fan)supplies the
required air into the furnace for combustion of fuel.
3. It is located between dust precipitators(ESPs) and Chimney. Obviously it handles hot air/dust. F.D handles air at normal temperature. The capacity/power rating of ID fan will be more than that of FD fan.
| Is This Answer Correct ? | 97 Yes | 16 No |
Post New Answer View All Answers
in control scheme dc logic wiring commonly using negative loop,what is the reason?if we use positive looping what will happen?
Write the force balance equation of ideal spring element.
How to protect sensitive loads such as Dosing pumps inside a factory from voltage surge/voltage fluctuation.
what is the difference between linear choke and suction choke?
Is it true that in the 3 phase transformer, the limbs of the core are at 45 dgrees to each other. if true, why?
I AM A ELECTRICAL PANEL BOARD DESIGN ENGINEER.IF I GO ANY INTERVIEW ,TECHNICALLY WHAT ARE QUESTIONS I WILL FACE FROM INTERVIEWER?
what is meant by CT`s saturation ? Can we use Metering CT`s with Protetection CT`s ?
How much weight an electrical engine can pull??
WHAT SHOULD BE THE BEST CURRENT RATINGS (PRIMARY / SECONDARY)FOR A CT INSTALLED AT THE INCOMING 11KV PANE? WILL IT BE CALCULATED ON THE BASES OF MAXIMUM DEMANT VALUE OR ON SUM OF ALL TRANSFORMER'S KVA? NOMALLY MAX DEMAND REPRESENT THE MAXIMUM OPERATING LOAD OF THE PLANT AND TOTAL KVA OF (SAY 5 NUMBERS TRANSFORMERS) REPRESENT THE CONNECTED LOAD. WHICH i.e. MAX DEMAND KVA OR CONNECTED KVA ARE BETTER TO USE FOR CT CURRENT CALCULATION? PLEASE ANSWER.
As i want some model question paper in basic computer science and history please send me immediately sir
i want to know d working mechanism of tafe tractors next i like to know d engine type of apache bighs can anyone help me
Do closed loop systems require manual input?
If I have Energy Meter Ratio as 100:5 & Also I have CT Ratio as 50:5 then what will be my multiplying Factor(M.F.)
What is difference between isolator and circuit breaker?
Inductor and capacitor........power in one phase and ...... in it another phase.