Answer Posted / saravanan
primary side is low risistance dc current is flow burnout
the sisistance so not induced emf dc side is not frequence
applide
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
why the electrolyte level in lead acid battery is maintained 2.5 cms above electrodes?
What is the difference between electronic regulator and ordinary rheostat regulator for fans?
what will happen if there is a voltage leakage or current leakage in an electrical train
Refernce currents are to be generated using refernce cueernts how can this be done??
What is power distribution criteria for converting single phase unbalanced residential load to 3 phase star connected balance system. Does total KW converted to 3 Phase. Means Divided by root 3.
what is circuit recombiner and how it is different from circuit breaker
What is the difference between type1 and type2 relay protection co-ordination for motor feeders
why we change the direction of winding in rotor ?how we make the north and south pole?
What is the best thing to protect the motor from running over full current. CT or O/L or pressure transducer at the given pressure rating
How to check the cable fault / hv test of transformer cable.
can I improve the furnace power factor (10 mva transformer) by adding a capacitor bank before the transformer.Does system power factor vary a lot with the furnace PF?
Will an earth leakage trip be activated if the component or wiring is faulty on low voltage equipment.Example An electrical Cat Scarer placed in the garden and water gets into the wiring.
What are the advantages of vscf wind electrical system?
Suppose a 3 phase, 2 pole, 440V induction motor is driving a flywheel of 600mm diameter, 150kg mass. By using v-belt and pulley, the speed is increased to 4500 RPM. What will be the effect on motor current?
take 100kva DTR( delta/wye ), what ll happen if we connect 11kv to LT side instead of connecting to HT side? will the DTR behave as a step up transformer or something else????