Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between Earthing,Grounding and
neutral?
- 3 Answers
- 8154 Views
- Biocon, Tata Steel Limited, I also Faced
- E-Mail Answers
Answer Posted / simon
All r safety from the harm full effect towards phase/+ve.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Form S and "c" license application both are same? @ tneb portal
Explain about how is it working Earth fault'relay and wahts the resistance value of earth bed
Pl.brief me about Electrical power distribution system from Main generating station to Industry.What is the use of in between station.
can anybody send me syllabus of rrb section engg (electrical). and also send previous question pepar...
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
explain which quantities change in the starting and the and the running condition in induction motor
What if the difference beween internal and exrteranal LBB?
Determine the BTU size of an aircon for 20 sq metre room
WANTCONTACT NUMBER & EMAIL/ WEBSITE TO CONTACT THE SECRETARY,MADHYA PRADESH LICENSING BOARD(ELECTRICAL),K- BLOCK,3RD FLOOR,SATPOODA BHAWAN,BHOPAL
can we start slipring motor on star delta like we start induction motor ? if yes where will we connect ?
What is the role of Dedicated earthing in UPS System?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
how to calculate transformer turn primary & secondary side 11kv to 420v
Differentiate between Zero and Negative sequence current
A car's starter motor draws a current of 100 A at 12,0 V when starting the engine. The mechanical power required to turn the engine is 960 W. At what rate is energy from the battery converted to non-mechanical forms of energy?
