Interested to Buy Any Domain ? << Click Here >> for more details...
can we use generator(a.c) as a motor.if so how if not why.
- 2 Answers
- 4287 Views
- I also Faced
- E-Mail Answers
Answer Posted / simon peter
Yes but the input supply should b ac supply......
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
WHY BREAKER ARE USED IN SUBSTATIONS?
What is CCM in Electrical ? where can we use this material?
What is EMC filter in VVVF Drive ?
What is electrical cable termination
What are the basic elements used for modeling mechanical translational system?
Why is a synchronous motor always star connected??
Sir, I have applied for the of Assistant.engineer of NPDCL. please send me all AP TRANSCO AND JENCO solved papers of previous exams . I requested send me the papers to my id as soon as possible (rajanikanth_peddi@yahoo.co.in) (This is very urgent) Thank You,
Can a generator runs after getting 1st stator earth fault.
What is different type of Electrical curve and how it protects the equipment's while up-normal situation?
describe the Tranformer testing procedure
how to check avr of dg set of 125kva
I have an existing old MCCB. ABB Model SACE, the rating are: Ue = 660 volts, Iu =1250 Amps, 3 poles, Ith (max) =800 amps at 45 deg C. I need a circuit breaker for my 3 phase motors, 380 volts 60 hz. the supplier required the minimum ampacity of the breaker to be 911 amps. can i use this breaker with rating of Iu =1250 amps but Ith = 800amps maximum?
What is the rating factor for copper cable ( Specific value according to the type of laying ) & the voltage drop?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
how to carried out tan delta test in 11 KV alternator ?
