Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / abhishek rathore
4mamp current signal consider as 0% if sensor or wireing fault then signal goes to 0mamp controller or operator understand signal fault mode goes.1,2,3mA not consider because bydeafault 1-3% signal present in the systembut 4mA not goes to signal bydefault .so we are consider 4-20mA signal
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
How do bending tubing provide better measurement than using tubing fittings such as elbows?
Any one can help me to identified, how can we interchange the device in FF
can any one tell me when ongc placement test and its forms is available????/ pls tell me if u know
How addressable fire systems work? Pl. send details with architect.(Loop), also send details regarding Gas system. Pl. help me.Thanks
With N nodes and B branches what will have a network ???
what are the definitions of input, output, command & signal according to instruments controlled by PLC using DCS System?
why orfice is not used for main steam flow calculation
Can combine control system for Emergency control system (ESD)and Fire & Gas System ( F & G) is possble to built and offer to client? Can such system is as per Norms in India?
Explain how thw analog to digital converter works with the circuit diagram
model question paper of instrumentation for Jindal GET 2010.plz reply sudhanshukumar08@yahoo.com
What is the GK Value in Flowmeter?
Hi i am aneesh, done btech in applied electronics & instrumentatiin. And then i took mba in finance & marketing.After that i got placement in finance co and worked there for 3.5 yrs.Now i wanted to come back to engineering job.But without engg experience, i may not able to find an opening.i have done a course related to flow meters and ite calibrations. Kindly suggest where should i try to get a job?
What is the use of temprature compensation?
how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.
How digital input and digital output 's are working in dcs
