Interested to Buy Any Domain ? << Click Here >> for more details...
why we need external pull up for port 0 of micro-controller
8051?
- 2 Answers
- 5881 Views
- I also Faced
- E-Mail Answers
Answer Posted / shantanu
Pull up & pull down resistors must be requird I2C & Micro-
controller/ADC. The output port will be tri stated means 1
or 0, we can't prdict.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What are the disadvantages of bjt?
Why does all cellular networks have same shape of sim?
Pl. Brief about DNC.
When we trim a resistor, we are A Making a fine adjustment B Reducing its value C Increasing its value D Making a coarse adjustment
Tell me what are the components has to be done in fpga board (altera)?
How are electrons in an atom visualized?
State the difference between ac and dc voltage.
Op-amp is used mostly as an integrator than a differentiator. Explain why?
1. What is leakage current? 2. Transistor VI characters? Explain. 3. What is dc load line? 4. Differential amplifier circuit. 5. Recursive interrupts. 6. Diagram case microcontroller and Eprom 7. Use of grey code? 8. Design counter from 1 to 11. 9. Characteristic impedence?Z0 value of probe used in lab. 10. 3 input TTL logic. 11. What is Pseudo random sequence? Why it is called so? 12. What is stack? 13. Different types of voltage regulation?
Hi, i have to appear in L n T managment trainee interview ..please suggest some questions if u have faced similar interviews..!!!
interface 8085 microprocessor with 4K RAM, 256 bytes RAM, 2K RAM and 6K ROM using decoders and gates?
Which of the transistor currents is always the largest? Which is always the smallest? Which two currents are relatively close in magnitude?
What is a trducer and trponder?
Define input offset current.
Why value of rx level is always negative?
