Interested to Buy Any Domain ? << Click Here >> for more details...
If we increase PI controller what will be action.
- 1 Answers
- 4732 Views
- IMECO, I also Faced
- E-Mail Answers
Answer Posted / kanishka verma
if we increase PI the overshoot will increase which cause to
the system increased its settling time to the set point.
| Is This Answer Correct ? | 12 Yes | 1 No |
Post New Answer View All Answers
Q1: Consider part of a control loop, which excludes the transmitter, consisting of a process, a controller and a control valve which may be represented by two dead times of 0.5 min each and three exponential lags of 0.8 min., 1.0 min. and 1.5 min. respectively. We wish to express this system as an overall first order plus dead time (FOPLD) model ie gain, time constant and process dead time. (We will see later that this is often done, to simplify controller tuning). For this exercise, gain is considered to be 1.0. (A) If the transmitter is a flow transmitter whose behaviour can be described by a dead time of 0.2 min. and an exponential lag of 0.5 min. in terms of the overall dead time and overall first order lag how can the system behaviour be approximated ? Overall dead time = Overall time constant = (B) If the transmitter is a temperature transmitter with a temperature sensor in a protecting well whose behaviour can be described by a dead time of 0.7 min. and an exponential lag of 15 min. how can the overall system behaviour be approximated now? Overall dead time = Overall time constant =
how to tune siemens sipart electro pneumatic positioner..plz tel me..
What are the key features of a Distributed Control System? describing the various layers (sensor through to business system interfaces) as well as the hardware, software and security aspects of the DCS.
What is zone,loop/fire alarm system?
in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
what is the field bus calble ? what are diffrences in orang colur cable and black coular calble ?
Whether the DI, DOs shields can be connected with Analog Input Shield Earthpit?
For crude application in floating roof tank, how to calibrate a DP Transmitter? How is the floating roof weight considered?
What is standard procedure of manual mapping in Radar type level transmitter?
what diffrence b/w plc s7200,300,400
I faced several time siemens ps2 positioner automatically getting Chang in it's set point direction after auto calibration So is there any causes biside this or any permissives ?
what is the difference between attemperator and desuperheater ?
what is cold loop? difference between hot and cold loop?
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
