what is difference b/w CFL and Ordinary lamps? which one is
useful for power saving?
- 5 Answers
- 5540 Views
- I also Faced
- E-Mail Answers
Answer Posted / kj
CFL is compact fluroscent lamp.
Like all fluroscent lamps they use less power for the same
light. 11 watt CFL is the same as 75 watt ordinary lamp.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what's prime importance of protection in electrical system.if protection system don't work properly what can happen in electrical system?
what is the Pickup/drop off ratio in BCPU relays
How to use earthing on shipments.
What is ST and specify its range of voltage.
what is the difference between active power and reactive power and apparant power in practical as well as theoritical
HELLO SIR, IAM PREPARING HPCL EXAMS. SO PLS SEND MATERIAL OF HPCL ELECTRICAL ENG..TO VIJAY_8888@YMAIL.COM
7- What is the Dissipation Factor and the difference between it and Insulation Resistance Test? 8- What is the task (function) of DC and AC reactors in power plant? 9- What is the task (function) of (open delta with earthed) in some types in transformers? 10- What is the base of the selection of the vector group in transformers? 11- What is the zig-zag transformer and its function by drawing in large detail? 12- What is the polarity ? 13- Why we make short between phase(R) in high side and phase (r) in low side in vector group test? Where High Side ( R ,S and T ) and Low Side ( r ,s and t ). 14- What are the time on delay and time off delay? 15- What is the vector group? 15- What is the task (function) of different types of vector group such as Dyn11 , Dd0 , YNd1,……..,?
I Want randstand placement papers
what is counter poise conductors
why dimmerstate always connected in star connection? what will happen if it connected in delta?
Pl.brief me any electrical major fault you have rectified.
it is possible to measurement of tension of slipring induction motor(SRIM)carbon brushes, any maesuring instruments are available in the markets.
A 100W electric lamp is supplied from a 115V, 60HZ source. The peak instantaneous power dissipated in the lamp filament is
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
Thermal withstand capability under full short circuit conditions, in terms of number of times of occurrence of short circuit and corresponding anticipated percentage reduction in transformer life.
