is it possible to say motor horsepower number without seeing
name plate(when name plate damaged)
Answer Posted / murugavel
can you find in motor full load current and multiplication in voltage you will find out motor KW after 1KW= 0.742 hp
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
if we apply 1000ADC instead of 100ADC or We apply 50ADC instead of 100ADC,What will be happened in the test result value.Pl explain
How to protect sensitive loads such as Dosing pumps inside a factory from voltage surge/voltage fluctuation.
what do you mean by every IC 74 first digit.why are you using this no.why not using another no.
1)we have 1000 cfm Blower,Dia-1Mtr,Velocity of air 94 m/s 2)We have Natural Air velocity 94m/s 3If i Put Wind Mill in natural air ,speed is 94m/s Then it will generate Assume 100kw 4)If i put same wind mill across the Blower,air speed is same 94m/s now the Question is Will it generate 100 kw?
How many types of faults are there in 3 phase power system?
How much ph is maintained of water electrolyte which is used in LRS for 1200 kw slipring induction motor ?
how point on wave controller works.
Can i replace Earth leakage relay to the faulty Earth Faulty Relay
Why squirrel cage motor can only use with low starting loads ?
Why phase sequence must be same in any ht motor or generator circuit?if phase sequence doesn't same whatever will be affect on circuit?
I am going to appear RRB Sr. Section Engineer Exam, Electrical. Can you send me previous year questions of RRB Electrical engineer. specially Section Engineer questions. my email id is likerahulworld@gmail.com
What is shunt voltage and u v voltage witch one best
sir i used 3 hp of motor for spraying pump, other home light and other home items which size of allminium pvc wire ix used
what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero
can we conduct the swineburne's test on a dc series motor? why?