Interested to Buy Any Domain ? << Click Here >> for more details...
What is the basic principle of vibration measurement by
BENTLY NEVADA vibration measurement system? and Why it
gives the -ve voltage output?
- 14 Answers
- 135097 Views
- Ensol, GNFC, Reliance, Siemens, I also Faced
- E-Mail Answers
Answer Posted / ramesh
what is purpose of proximity ? why use proximity with
vibration system?
| Is This Answer Correct ? | 6 Yes | 3 No |
Post New Answer View All Answers
What are different types of orifice plates? State their uses.
define feed forward control loop with example and drawing?
on interface level transmitter model(RTG3302-EMERSON) What is threshold valve how can we select correct threshold value T1,T2,T3,T4 When interface water & hydro carbon
Make a ladder diagram on LSL valve will close, on PSL valve will open and start the motor
what is the difference between active & reactive power?
How addressable fire systems work? Pl. send details with architect.(Loop), also send details regarding Gas system. Pl. help me.Thanks
What is rang ability?
DEAR SIR/MADAM MY NAME IS ARKAPROVA BHATTACHARYYA.I AM A FRESHER INSTRUMENTATION ENGINEER.CAN YOU PLEASE SEND SOME QUESTION PAPERS OF GRADUATE ENGINEER TRAINEE EXAM OF DVC(DAMODAR VALLY CORPORATION).MY EMAIL IDs ARE arka_aec@rediffmail.com.
Why we are using reverse action in displacer types level transmitters on some Vessels?
What is cut off relay? And why use in PLC and DCS?
Explain an adaptive / self-tuning controller’s major draw card.
Draw bode plot of any transfer function. Why is plotting bode necessary?
How will you test a transistor with a multimeter?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
what is compensation? temprature & pressure
