Answer Posted / tushar
In DC supply transformer may burn as there is no changing of
flux.
Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
Why corona leads to production of Ozone and glow of the color VOILET?
How to select cable the size, what is the parameters use and what is the formulas use for this cable size calculation?
How to calculate the input cable rating for 10kva ups (3phase input and single phase output and also 3phase output, battery rating 65Ah)provide the formula also.thnx
Anybody tell me about modbus hex address of l&t trivector meter er300p??I want to read voltage,current,kwh etc via rs485...If anybody have a manual then send on my mail..Brijeshmodi18@gmail.Com
State kirchoff voltage law?
If any cable burnt how can we identify it burnt by high current of high voltage?
Hello sir i m student of gtu .what is idp.
nwhat are the main Components of servo motor?
What the main causes of transient interruptions on Over-Head Distribution Lines?
What are the types of control system?
What is the basic of DTH.
is this the formula of building wiring to get the main breaker.Watts/volts*.8%+higher motor*(25%)=ampere. yes or no or send the correct formula for building wiring.
how is positive, negative, zero sequence is happen.. how is effect on 3 phase system
why on delay timer used for fully automatic star delta starter?
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com