Interested to Buy Any Domain ? << Click Here >> for more details...
Why we use series reactor in power system?
- 9 Answers
- 24062 Views
- Cadbury, HEG, Uttam, I also Faced
- E-Mail Answers
Answer Posted / mangesh karande
To limit short circuit currents and thus to reduce fault
MVA. Also to keep to sources permanantly parallel.
| Is This Answer Correct ? | 5 Yes | 2 No |
Post New Answer View All Answers
please tell me when we start motor without load in star or delta connection whose current above condition,pl write formula
HOW TO CALCULATE EARTHING SIZING?
which is the best institute for PLC,SCADA,DCS in hyderabad
Explain and give examples about VCB?
What happen to the transformer if the OLTC frequently used for lower and raise occured 50times daily?
when we have to use UPF wattmeter and LPF wattmeter? what is the difference between UPF and LPF wattmeter in terms of construction?
State The Difference Between Generator And Alternator?
How many gap between finger contact in a.c.b. and v.cb.?
HOW MUCH CURRENT DOES SYNCHRONOUS MOTOR TAKES AT SYNCHRONOUS SPEED IN NO LOAD CONDITION ?
What is the one main difference between ups & inverter ? And electrical engineering & electronics engineering ?
how to calculate units consumption for a 12 hp motor /hr.
in a simple IDMT relay we use neutral point of ct for earth fault then what is the requirement of neutral ct and cbct?
Suppose a 3 phase, 2 pole, 440V induction motor is driving a flywheel of 600mm diameter, 150kg mass. By using v-belt and pulley, the speed is increased to 4500 RPM. What will be the effect on motor current?
what is the ms flat constant for calculating earth mat design calculation?
Where is servomechanism used?
