Answer Posted / kavaskar
M.P.C.B=Motor protection circuit breaker.
it is a electrical device,it is used to isolate
(protect)the fault part of the powersystem at abnormal
condition,motor protection means isolate the motar fault at
running condition..........
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
I am going to appear for the RRB Chennai Section Engineer online exam. Please send me the question papers from 2001 to date to my mail id:upendrakrishna20@gmail.com,plz send me ,or send any other rrb papers plzzzzzzzzzzzzzzzzzz
Why are lt windings placed near the core?
What are the types of feedback oscillators?
why do we carry out winding resistance test?
we have amp, voltage, kw, length detail then how to calculte copper & alluminium size of conductor of 3-phase induction motor
What is the basic principle of welding process?
in a silicon diode we can measure .7v in a voltmeter.but why we can't use this voltage for using?
What is the tension required for the 25000 CFM AHU belt
In parallel operation time both NGR’s close or not close if both close what will happen
why magnet has north and south poles only why not east and west and why we are considering as north and south poles? why cant we consider as east and west?
What is the general power consumption rating of CPU CRT type and Flat type, Monitor,Printer, projector, Scanner?
1.why should we connect the measuring instruments in l.v side in short circuit test of a transformer? 2.why the power factor is less in open circuit test of a transformer?
How to checked frequency drive output voltages?
direction of tarbine& genrator
I have a drawing of a wound rotor induction motor for a crane. This crane motor has 5 forward speeds & 5 reverse speed implemented of course with different amount of resistance for each speed setting selected. What has got me scratching around is the fact that 8 of the 10 speed selections switch in uneven (unbalanced) amounts of resistances on each of the 3 connections to the motor's rotor.Can this be possible? I would have assumed this would produce unbalanced rotor currents and therefore vibration in the motor. I would greatly appreciate anyone's comments on this. Many thanks, Confused.
