what is the principle of switch gear? where its function ?
Answer Posted / glenn mendoza
Switchgear is a device or aparatus to connect incoming power source to busbars, close and open the ACB.. built in CT,PT and aux. Devices for monitoring the voltage,amps,pf,kwh,mvar. And have safety device for earth leakage,under/over voltage, over/ current trip.
Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
What is servo motor and what are the applications of servo motor?
Whether amorphous core transformer is available in India?.If available then up to what rating of voltage and KVA?.
WANTCONTACT NUMBER & EMAIL/ WEBSITE TO CONTACT THE SECRETARY,MADHYA PRADESH LICENSING BOARD(ELECTRICAL),K- BLOCK,3RD FLOOR,SATPOODA BHAWAN,BHOPAL
what r PID controllers?why they r used?what is there purpose?plz Explain in detail
What happens if we give the supply to the rotor of induction motor and make its terminal shorted?
sent to a site and asked to explain how you would like a twenty seven flour building should be supplied with lighting and sockets plus a water boiler.
what is LSR?
IF TVM OF TRANSFORMER SHOWS POWER FACTOR ON 33 KV SIDE AS 0.97 LAGGING AND ON 132 KV SIDE IS 0.75 LEADING.IS THIS CORRECT.WHERE IS PROBLEM.
why dc is used in control circuits for MV & LV switchgeras instead of ac
how you configure motorvision relay (L&T make)from DCS
An automatic water heater is an example of which type of control system?
How one may guess the direction from which the distribution line is incoming if there is no pole plate on poles?
What is the formula for calculating impedance of transformers connected parallel at fault level 50KA?
Earth has zero potential then what would be the neutral potential ?
at what rate the micro controller increment its timer....is it 1micro seconds or 1/(12*10^6) seconds