Interested to Buy Any Domain ? << Click Here >> for more details...
As load in a transformer increases, mutual flux linkage in
core=
A increases B decreases
C not change D first increase then decrease
- 2 Answers
- 8335 Views
- I also Faced
- E-Mail Answers
Answer Posted / rohit agarwal
see in a transformer for producing flux only no load current(magnetizing current)is required.now as load is put on secondary side by lenz's law flux in core decreases which is compensated by drawing greate current from primary.thus flux linkage remains constant.
| Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
Any Electrical Engineering jobs?Please refer for interviews. Thank you
What is a differential amplifier?
can any one know is sbi interview based on merit or based on roll number
Brushes are placed at magnetically neutral axis,when brushes reach that point,the armature conductor gets shorted,but it can be seen that the dc supply is also shorted,wont that get damage? help me plz
how to Select its CORE in electrical cables based on its applications? or Application of various types of electrical cable based on it CORE?
what will be project cost for 100 kv transformer connection under oyt scheme.
Proviiding the Dedicated N earth and individual Body Earths ,Finally these all looped /Now my Question :- will it not harm in case of Transformer Fault current flows in Dediacted N Earthing to Looped Body Earthing.
Define the overload capacity of the motor?
Will an earth leakage trip be activated if the component or wiring is faulty on low voltage equipment.Example An electrical Cat Scarer placed in the garden and water gets into the wiring.
Both generator parallel condition shared load equally but one genrator taking ampere more than the other what are all the causes to make like this
WHAT ARE THE DATAS REQUIRED FOR PROTECTION AND METERING AND CONTROL AND LOGIC PREPARATION,HOW TO STUDY THE PROTECTION AND METERING?
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
Explain dc generator with its types?
how is working bearing heater?
What is the RMS and DFT principle of analogue maesurments. Which way they are advangages. where which princples give optimum results.
