In 3 phase induction motor even with low Voltage it reaches
nearly it's rated speed why? (for example instead of 400V it
reaches with 250V)
- 2 Answers
- 3477 Views
- I also Faced
- E-Mail Answers
Answer Posted / narayanan.m
due to high starting torque
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
how to calculate the power factor when instantaneous voltage and current has harmonics in it ?
How to do cable sizing calculation for 750 A Neutral Earthing resistor for 33kv. the 33kv cable going to swbd. is 630mm2 3 runs.
how the B-H loop obtain under the static condition
rajha power sector details
before transformer oil dielectric strenght tests are taken the oil should be allowed to settle to remove option 1 air bubbles 2 gasses 3 contamination 4 water
What difference between ref protection and differential protection ?
how can we design robots
Transmission voltage is kept 11KV,33KV,66KV,132KV,220KV due to form factor. What happen to 400KV and 765KV transmission voltage?
Explain bypass capacitor?
Why do we apply both Differential and REF (HV and LV) protection schemes on YNyn configuration of a transformer?
how can i reduce sparking without stepdowning the voltage
is it possible to have dc motors on single chip
can the measured percentage error during calibration of single phase energy meter be negative?
If we impress a dc voltage of 230 V on an unloaded 230 V, 50 Hz transformer it wi A give high secondary voltage B burn out C give secondary voltage as per K D none of these
what is meant by moulded case circuit breaker ?
