WHY WE WILL USE 0-24VdC IN ELECTRONIC CIRCUITS AND
INSTRUMENTATION TRANSMITTERS?
Answer Posted / kapil sharma
Because most of the electronics ICs and devices DESIGNED FOR 0-24 VDC
Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
what is The specifications for oriface instalation
What are the maximum packet size of: a) HART b) Profibus DP c)Profibus PA d) DeviceNet e) Foundation Fieldbus
How many ohms are required for proper earthing?
What is exact difference between the panel earthing and system earthing in DCS system. What is the value of resistence.
Instrumentation symbols interpration, P& ID, Logic diagram analysis, Electrical drawing analysis.
I want to know about DDCMIS in detail ? please explain it. Also give name of reference books in which it is explained in detail in very simple manner.
Explain the working of an electronic level troll.
What is the difference between working pressure and calibration pressure of a control valve
What is offset in a control system.
DEAR SIR/MADAM MY NAME IS ARKAPROVA BHATTACHARYYA.I AM A FRESHER INSTRUMENTATION ENGINEER.CAN YOU PLEASE SEND SOME QUESTION PAPERS OF GRADUATE ENGINEER TRAINEE EXAM OF DVC(DAMODAR VALLY CORPORATION).MY EMAIL IDs ARE arka_aec@rediffmail.com.
how to convert MA in to measuring values..and how mwasuring values into MA ?..plz ansr.i have intervw
A flange is used for instrument connection for a system with a design temperature of 316C (600F) and a design pressure of 1000 kPa (145 psi). What is the class rating of the flange to be used for this application? Explain your answer
If P will increase then what will happen with PID?
What are primary elements of measuring pressure? Which type of pressure can be measured by these elements?
what is the electrical operation procedure for switching on 27.6MVA electric furnace.