in 33/11kv stepdown transfomer, transformer will stepdown to 11kv & remaining 22kv where it will go..
Answer Posted / prof. dr. k. manjunath
Transformer transfers the power from one circuit (primary)
to another circuit (secondary) at constant frequency. If
voltage at circuit is higher then current will be lower in
magnitude whereas another side, the voltage will be lower
and current will be more.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
How to know any size of cable if there are not written on cable? Answer must be theurical not by experience.
Can 33kva/415v transformer be run underground? If the answer is yes why and if the answer is no why?
how to calculate the mesh earth network resistance in such substation, is there any recommended resistance values with references , thanks!
What is a single phase autotransformer?
How to work meggar?
I am an American living in Vietnam and I have recently gotten a refrigerator from Japan and it is rated for 100 vac, but the power here is 220 so I bought a voltage stabilizer it has a 1 kva output rating. Can you please tell me what the amperage is? I'm confused and without a working fridge.
i want wipro vlsi placement pattern please send me
What is the accepted limit to increase the choosen transformer capacity over the load and why ?
what is the condition for YnD11
What happens to voltage when current is zero?
Explain the iniluencc of short circuit ratio on the pert'orniancc of synchronous machine.
Why open circuit test of transformers is conducted at rated voltage??Why not any other voltage??
how to copy from plc ge fanuc versamax series,all input and output, adress, and printout.
How is operate breaker failure scheme in substation
i have total 8 dg sets for synchronizing and 2 buscoupler,1 sectoin dg no 1,2,3,and 2 sectoin dg no 4,5,6,and last section dg no 7,8 ....if buscupler no 1 and 2 is off mode ..than dg no 1,2,3,will synchroniz of another dg sets?