why we are connecting the alternator to a steam turbine of
higher RPM then the rated RPM of alternator?
For example:( connecting 1500 rpm alternator to 7600 rpm
steam turbine). we can directly connect the same rpm
turbine to alternator know??? is there any special reason ???
Answer Posted / kj
An alternator cannot be built to run faster that 3000 rpm
if it is to produce 50 Hz. and often is made to run at
1500RPM.
Turbines are not efficient at those low speeds so they are
operated at higher speeds and gearing must be used to
change the speed down to the maximum speed of the
alternator.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Why the field rheostat is adjusted such that the voltmeter reads 380V
How npn and pnp transistor works
WHY THREE PHESE SYSTEM VOLTAGE APPLIED IN 440 VOLT
what is calculation mathod/formaulla for deciding Size of busbar (Copper/ aluminum)for L.T. panel on Various Fault level like 50kA,25kA,10kA
what is LSR?
Is it posible to instal one more SMDB from the existing SMDB and is it practical.
hi friends i m from electrical branch and seeking for tech. + apti. both papers of hpcl plz get it available as soon as possible
what is inter connected dc generator?
What are the parts in a inverter?
which VFD is better ( LT or HT)
Define conversion efficiency of a power amplifier. What is its value for class c power amplifier?
How much ph is maintained of water resistance starter for slipring induction motor ?
What is the maximum number of swithes that can be connected in series up to down stream point in an LV Distribution system?
The metal-enclosed switchgear and controlgear is subdivided into three types: 1. metal-clad switchgear and controlgear; 2. compartmented switchgear and controlgear 3. cubicle switchgear and controlgear. What is the main differnence between them. State some example.
State the points to be considered for selecting a particular type wiring.