Answer Posted / harsh shah
It is a isolator where the three pole phases are aligned
digonally ie. all the pole phases are connected one behind
another so that the jumpering can be done on the bus bar
Is This Answer Correct ? | 14 Yes | 1 No |
Post New Answer View All Answers
what is the power factor used by the PHCN in nigeria? 2. what is the difference between an alternator and generator. 3. Generation of poweris in KV but how is transmission is in MW. 4.If the transmission of power is 20,000MW how can it be increaesed to 80,000MW
Please explain, how to test vector group of tranformer(Delta y1) . Thank
Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?
What is the function of electron gun used in crt?
how to store the thunder power?
how unidirectional torque is produced in DC motor?
can anybody sent me power grid questions. what subject should i prefer for preparation?
What are the different types of controllers?
what is earth-fault?when it occurs? to check where it occurs what type of test should we do?
Why a tesa lamp is glow between two phase?
how to find out cable size if load is 2800 watts, 230 volts AC supply and load distance is 1800 meters
In a tap changing transformer where is the tap connected, is it connected in the primary side or secondary side?
how to calculate transformer turn primary & secondary side 11kv to 420v
what is relay what is protection & contact multiplying relays where it is used function in brief
Can any one give an explanation about rating factors of cable? if we are laying the cable on the air with an temp 15 degree then rating factors will be 1.15 and if we are laying the cable on the air an temp 60 degree then rating factor will be 0.76 please describe it and what is the difference between rating factor and derating factor?