Answer Posted / abm
M=LdI/dt. When we switch
on the dc supply,its value will
increase from zero to a
particular value within a very
small time interval,which
means dt~0,so the value of M
will be infinite.so Output
voltage will be high
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How much current will a 5 HP delta connected motor at no load will take?Is tat need a starter
what is the current setting for different relay protection for transformer .
Can any answer me ,What will be the range of C.T coil for L&T energy meter EM301 used for 180 kva DG set
Is it advantages of having star-delta vfd than normal star vfd , if yes why?
What is a slack bus?
explain PV modules in solar energy generation.
what is kvarh? Please define it With calculation General motors ?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
if we give 60 hz single phase supply to the transformer used in europe , than what will happen
WHAT IS SHORT CIRCUIT STRENGTH OF 100 AMPS MCCB?
what is fault level of power system ?
What are linear and non-linear systems?
how to calculate earth fault relay current and CBCT ratio
How we can calculate the consumption in kwh of motor on basis of kw @100% load, @50% load & @ no load.
what is meant by brushed alternator & its working principle ?
