Interested to Buy Any Domain ? << Click Here >> for more details...
For the same power rating,which motor is bigger in size,AC or DC?
- 9 Answers
- 18702 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / mahesh
i think dc motor is smaller than ac its because in dc motor we can directly take the current from armature where as in case of ac motor it is taken from brushes and slip rings and extra components may include so the motor size is more for ac and it is less for dc
| Is This Answer Correct ? | 1 Yes | 10 No |
Post New Answer View All Answers
What current position are you holding in your current company?
from which subjects most of the technical que will b asked for hpcl(electrical).pls help me
can any tell me why slope 40% and 80% is calculated in differential protection?
Why the standard of ambient teperature mentioned as 40 degree celcius in machines.
1. What is maximum permissible distance between smoke detectors ? 2. How do we decide number of smoke detectors required in a large office, warehouse, hall etc ? 3. What should be maximum height of smoke detectors ? 4. Where do we use heat detector, optical smoke detector, temperature sensitive detector ?
Why we find the sensitivity for the CT's to check?
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
what happen if generator of micro hydro running at only a small percentage of its capacity, as a comparison, if the diesel generator that runs on only a fraction of its capacity there will be a wet stacking
What is the height of DA, DAL, DB, DC & DDE tower?
What do you mean by screen of power cables?
How can get elongation of 2 k.G aluminium, if elongated aluminium dia is 2.5 mm?
Advantage of LT panel vs HT panel
Following test should be conducted to find out relative polarity of transformenr terminals A no load test B back to back test C phasing out test D none of above
What is “pu” in electrical engineering?
How to protect sensitive loads such as Dosing pumps inside a factory from voltage surge/voltage fluctuation.
