Answer Posted / sudhakar

hi,

ima sudhakar centrifigul compressure saftys,

regards,

sudhakar,

What are hydraulic and pneumatic machines?

1045

---

Properties of F.O. the cause damage on auxiliary boiler.

1944

---

when do we use roller bearing, deep groove ball bearing, angular bearing, sealed bearing, semi sealed bearing, unsealed bearing, anti friction bearing, journal bearing, thrust bearing

2099

---

Define earth lamp?

1933

---

my dad is refused 8 times in visitor visa? now my dad wants to go usa only? tell me what he can do? whats the reason?

1994

---

should cutouts made in main header of metal ducting be deducted from duct measurement.

2259

---

Steering handle (round dial) of motor vehicles (CAR,BUS,LORRY) wiil be designing with two cross supports without 180 degree straightness( it will be little bit cross). Why?

1961

---

How much is 1 kn in kg?

1034

---

Enthalpy and entropy are functions of one single parameter. Which is that ?

1071

---

sir please send previous question papers of technician grade III of all rrb's. thank you

2013

---

What type of cross-section is usually of a chisel?

1149

---

Hai, iam renjith. my qtn about the calorex heat and cool pump. What is the reason of the above machine is trip on high pressure. r134a gas using in this system. 8 months old. model is calorex propac 90(3 phase). This system has 2 compressor. Both are starting on 13amps after that rise up to around 21 within 1 minute. After will be trip on high pressure. Showing 68 psi in suction side on standby mode. Can i have a solution without delay? Renjith renjithngm@gmail.com

2096

---

Will going from a 3 tap to a 6 tap increase water pressure?

1016

---

can a deareator be placed at any height with care that suction (NPSH) for feed pump is satisfied

1929

---

can i apply for rrb with my provisional certificate..........

1855

---